Could be possible heat the two hotends+heatbed at the same time with Materialise?
I can edit the gcode file and remove M109 G-Code, but could be fine if exists any automatic solution.
That is a good question. In my case, the feedback about the temperature seems to be very slow, or to send the new heat only when it reached the requested heat, any suggestion?
The way that the bed and hot ends are turned on with the Materialise software is as follows:
1. Everything shuts down and first the bed heats up;
2. Next up the hot ends. This is how it is set up.
I would suggest not altering this and let the printer work as it should.
What you can do to shorten the waiting period when you are printing PLA is to set the temperature of the hot ends to 220 and the bed at 40 degrees. That way when you preheat the bed and hot ends they will reach the needed temperature and once you load the gcode it will not need so much time to start printing.
When you are printing ABS I am afraid you will have to wait.
Thank you Mircea.
Now I edit the GCode and I delete the M109 instruction because the hotend heat more fast than the bed. It is a "cheat", but it's work!
Thank you for updating the thread in case other people would like to try this.
Print settings in the Creatr Software can be directly updated in under 'print'.
The latest Simplify 3D profiles can be downloaded using the following links:
Bolt - Simplify3D settings
Bolt Pro - Simplify3D settings
To use the profiles, choose File, then Import FFF Profile and be sure to select the correct profile in your process. You can also watch this video.
Request more information on the Bolt (Pro) firmware and how to update this via the Ticket System
Bolt Pro Firmware