This manual explains how to remove the hot end.
Fri, 26 Jan, 2018 at 12:37 PM
Types of Adhesive Material
How Frequent Should You Clean and Change the Adhesive Material?
Cleaning the Print Bed
Adding New Adhesive Ma...
Wed, 28 Nov, 2018 at 1:37 PM
This article will show you how to how take apart the Bolt printhead Step 1 - Disconnect the hot end, drive unit motor and the cooling fans: Pic.1 ...
Fri, 18 May, 2018 at 10:44 AM
Hello and thank you for choosing the Leapfrog Bolt for your printing needs.
◄Bolt Motherboard► Connection Map
Mon, 30 Jan, 2017 at 10:33 AM
This article will show you how to replace the Y axis bearings on your Leapfrog Bolt 3D printer. Tools: - a 1.5 Allen key; - a flat head and start hea...
Tue, 14 Feb, 2017 at 8:40 AM
This article will show you how to replace the Raspberry Pi mini board on the Leapfrog Bolt 1. The first step you will need to do is to turn the printer ...
Thu, 23 Feb, 2017 at 10:39 AM
This article will show you how to replace a printhead drive unit stepper motor Step 1 Disconnect the wire harness of the stepper motor: Step 2...
Mon, 27 Feb, 2017 at 2:19 PM
Please follow the attached instructions to replace the ethernet cables.
Thu, 2 Nov, 2017 at 9:35 AM
To replace the motors you will need the following tools: Wrench 10 mm allen key 2 allen key 2.5 1. Please disconnect the printer from the power...
Thu, 17 May, 2018 at 12:43 PM
In the attachment you will find the document how to replace the head pcb's on the Bolt. 20171027_Leapfrog_Work_Instruction_Head_PCB_Replacement_v2....
Fri, 8 Jun, 2018 at 10:35 AM