Hi, I bought the cover so the bed of my HS would heat up quicker. But I mostly print ABS, and to heat up to 80C takes hours. HOURS! Oh, I could try with less than 80C, but really I'd prefer around 100C to get good adhesion. Do you see the bed temp graph on the picture? there is no temp increase in 30minutes.
HS stand for High speed? is this a joke?
Leapfrog, There are plenty of people on the forum experiencing this issue, time to do something about it.
best regards, Maarten
Did you open a support ticket?
Have you had a look at the solution knowledge base to be more exact the following link:
Also please note that the recommended max temperature for the HS bed is 80 degrees. Going over this limit can lead to the the bed not working within its normal limits. The bed will not reach the target temperature, or it will take a long time to reach the target temperature.
Print settings in the Creatr Software can be directly updated in under 'print'.
The latest Simplify 3D profiles can be downloaded using the following links:
Bolt - Simplify3D settings
Bolt Pro - Simplify3D settings
To use the profiles, choose File, then Import FFF Profile and be sure to select the correct profile in your process. You can also watch this video.
Request more information on the Bolt (Pro) firmware and how to update this via the Ticket System
Bolt Pro Firmware