Or call our technical support: +31852080825

Available Monday through Friday from 7AM to 3:30PM CET
Please create a ticket before calling and keep the ticket number at hand.
At the moment we are only offering support in English, so we kindly ask you to address your issue in English.
Start a new topic

Extruder Temp bouncing down 10 degrees during printing

Hello folks,


from a couple of month ago my printer (creatr dual extruder) has start randomly to not hold the temp of the extruder (both).


As you can see in the image below the temp fall down by 10/15°C, and the extruder  in that moment stops extruding, causing what you can see in the other image.


Already tried: 


-check all the wire OK move the wire all long during printing NOTHING HAPPEN switched the extruder NOTHING CHANGE

-refresh the firmware as suggested by the support but still no improvment

-PID tuning better alignment of temp reached and desired but still the falling down happen


Has someone experienced the same issue? or anyone have a suggest on how try to find out where the problem could be?


Thanks a lot for any suggestion, this is going me mad.

jpg
jpg

I had this too, you need to upgrade the PIC firmware of the printer( see downloads here somewhere) after that it works great. also do all other firmware upgrades.( new menus)

it is the PID. check here: http://creatrhs.lpfrg.com/support/solutions/folders/1000172527

I tried the PID Autotuning by sending the command manually, this improve the stabilitation of the temp, but the fault in the middle of the printing still happen. Still working on a solution.......

Hi,

Perhaps it is a trouble with the slicer. Try another slicer or change some parameters. I use Simplify 3d and I had this kind of trouble then I try to setup precisely the filament diameter (as I do with Slice3r) but for a not clear reason I get best result with the same Filament diameter (1.75) for all roll of filament and I modify only "extrusion multiplier"  (in the extruder section - left or right depending). I compute the extrusion multiplier: 1.75 / real_diameter (get with a caliper for each roll). This give better result. I suspect that there is some mistake in simplify 3D when calculating the amount of filament when using the filament diameter.


BR.
G* 

Hi Gilles and thanks for you answer,


do you mean that a 2% difference in the filament diameter could give that kind of temperature bounce( first Img )? 

Login or Signup to post a comment

User Manual

Quick Start Guide

Print Settings

Print settings in the Creatr Software can be directly updated in under 'print'.

The latest Simplify 3D profiles can be downloaded using the following links:

Bolt - Simplify3D settings

Bolt - Sync and Mirror Profile
Bolt - PLA, ABS Flex Profile
Bolt - Flex Profile V.1.1
Bolt - PolyPropylene Profile

Bolt Pro - Simplify3D settings

Bolt Pro - V1.1 - PLA, EPLA, Hybrid, PET-G Profile
Bolt Pro - V1.1 - Flex Profile
Bolt Pro - V1.1 - ABS Nylon Profile
Bolt Pro - V1.1 - PolyPropylene Profile
Bolt Pro - V1.1 - SS(0.5mm) Carbon, Wood Profile

To use the profiles, choose File, then Import FFF Profile and be sure to select the correct profile in your process. You can also watch this video.

Demo Print Downloads

Drivers Downloads

Software Downloads

Firmware Downloads

Request more information on the Bolt (Pro) firmware and how to update this via the Ticket System

Bolt Firmware

Download the Bolt 2.8.2 firmware here

Bolt Pro Firmware

Download the Bolt Pro 2.8.2 firmware here

Bolt (Pro) Video Library