Anyone having issues when printing from the USB stick?
Lots of strange behavior.
Have to start a pre-heat then immediately start a print from the stick for it to show it heating to proper temps.
Then the bed always shows it is heating to only "40" but it is actually heating up to the proper GCODE temp but does not show that until it starts printing.
Then the 0% complete always shows 0% through the entire print.
anyone see similar issues?
Print settings in the Creatr Software can be directly updated in under 'print'.
The latest Simplify 3D profiles can be downloaded using the following links:
Bolt - Simplify3D settings
Bolt Pro - Simplify3D settings
To use the profiles, choose File, then Import FFF Profile and be sure to select the correct profile in your process. You can also watch this video.
Request more information on the Bolt (Pro) firmware and how to update this via the Ticket System
Bolt Pro Firmware